The problem is not dreamup not working i'd the same problem before and it took me some time to flash my box. The answer to the question is when using dreamup u can start by using com1 and untick use network.:rangers2: Hi when using dreamup there acouple of things you need to follow i have read through the guid on how to flash the box which is detailed with very good instructions. If any errors appear, check all cables are connected properly and repeat the process but do not use the PC while it's runningGood Luck! If any errors appear, check all cables are connected properly and repeat the process but do not use the PC while it's runningĬlick Yes or Ya (depending on the version)Note: If you're flashing a backup image, select NO. Power off the dreambox for 30 seconds then power up The finished process should look like this: There will be a countdown timer at the bottom of the programĪfter the image is uploaded, it will be flashed to memory The image should then be uploaded to the box Note: If you're flashing a backup image, select NO. The message should now say 'Box attached and Ready'Ĭlick Flash on the right hand side and select the image to be flashedĬlick Yes or Ya (depending on the version) Null Modem Cable (this is NOT the same as a serial or rs232 cable, although it looks the same)ĭisconnect all cables from your dreambox, including the powerĬonnect the null modem cable to the dreambox and to your PCĬlick Connect and you will see a message like thisĬonnect the power and the bootloader should be copied to the box It may be that the process simply hung up during flashing or you accidentally pulled the plug half way through (yes it did happen to me). You won't be able to connect via ethernet so no ip address is required. If, for any reason, your box won't boot, you will have to use Dreamup to flash an image instead of Flash Wizard Pro or any other method.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |